Separte Layers for ICT Fixtures

Discussions about features that may or may not be supported by Sherlock in the future. All suggestions are welcomed. Registered users may post to this forum at any time.
Post Reply
jcuret
Sherlock User
Posts: 6
Joined: 10 Jun 2019, 18:12

Separte Layers for ICT Fixtures

Post by jcuret » 14 Aug 2019, 20:20

For the CCA viewer, it would be helpful to have separate layers for the Top and Bottom of ICT Fixtures as well as Mount Points.

I had to replicate a complicated fixture that covered like the entire PCB for the top and bottom, and it was very hard to create the bottom after already making the top. I just suppressed the top fixture (it just make it transparent) but is it possible to separate the layers into two like with components, heat sinks, etc.

Thanks!

natalieh
Site Admin
Posts: 75
Joined: 01 Nov 2016, 08:43

Re: Separte Layers for ICT Fixtures

Post by natalieh » 19 Aug 2019, 13:01

This is a great suggestion, and actually on our to-do list!
Natalie Hernandez, PhD
Sr. Project Manager
ANSYS DfR Solutions
natalie.hernandez@ansys.com

Post Reply