Improve CAF analysis properties

Discussions about features that may or may not be supported by Sherlock in the future. All suggestions are welcomed. Registered users may post to this forum at any time.
Post Reply
Jon
Sherlock User
Posts: 91
Joined: 04 Apr 2013, 12:11

Improve CAF analysis properties

Post by Jon » 03 May 2017, 03:21

Hi,
There will be some complex design with few drill layers. Can Sherlock CAF properties add in the tick boxes for all the drill layers. Then, the user can select which layer to be analyzed under CAF.
Thank you.
Attachments
more than one drill layer.jpg
more than one drill layer.jpg (143.32 KiB) Viewed 2391 times

Post Reply