The new feature in editing mount pads is very helpful, e.g. if the material of the mount pad is to be changed.
But if the mount pad are on different sides of the board Sherlock puts them all on one side. This leads to overlapping of mount pads and Sherlock will run without any warning.
Is it possible to show a warning as soon as mount pads are overlapping?
Mount pad overlapping
-
- Site Admin
- Posts: 19
- Joined: 05 Sep 2013, 09:53
Re: Mount pad overlapping
Thank you for the feedback. The issue of editing mount pads from various sides of the PCB being placed on the same side following the edit is fixed in version 5.0.2 which is expected to be released by mid-September. I will investigate placing a warning message when objects overlap each other.
Paul Walters
Computer Architect
DfR Solutions, LLC
9000 Virginia Manor Rd, Ste 290
Beltsville MD 20705
Computer Architect
DfR Solutions, LLC
9000 Virginia Manor Rd, Ste 290
Beltsville MD 20705